Machine Brand Recognition

Blog / November 9, 2026

How to tell a Deere wheel loader from a Case wheel loader by hood line and cab shape

Aerial view of an open-pit mine with heavy equipment and haul roads seen from altitude under a cloudy sky.

If you're working frame grabs or ortho tiles instead of walking the yard, "hood line and cab shape" doesn't mean what it means to a mechanic standing next to the machine. From altitude you get a shadow edge, a roof outline, and whatever color survived compression. Here's what those cues look like in aerial imagery, and where each one stops being useful.

Hood line reads as a shadow edge, not a profile

On the ground, a John Deere wheel loader's long, sloped nose is obvious. The hood drops in a continuous line from the cab to the grille, and on the newer G-series and beyond that nose sits well forward of the front axle. A Case wheel loader's hood breaks differently. It's a shorter engine deck relative to the wheelbase, so the forward edge sits closer to the front tires.

None of that helps you at true nadir. Straight down, a wheel loader is a cab blob, a boom line, and a bucket, and the hood is mostly hidden under its own shadow or washed out by whatever the sun angle happens to be that pass. What you get instead is a shadow length past the front axle centerline, and that's a usable proxy. Deere's longer hood throws a longer shadow forward of the cab, Case's shorter deck throws a shorter one.

It's not a clean read on every frame. Low sun angle exaggerates it, midday flattens it out, and a loader parked at an angle to the flight line skews the measurement entirely. Treat it as one input, not a verdict.

Oblique imagery is more forgiving here, if you can get it. A 20 to 30 degree look angle shows the slope of the hood instead of just its footprint, which is closer to the "by eye" identification a field tech would make.

Cab shape and color do most of the real work

Cab silhouette is a better nadir cue than hood line, because the cab roof is the tallest, flattest part of the machine and it reads consistently regardless of sun angle. Deere cabs run a rounder greenhouse with more rear overhang past the rear axle. Case cabs tend to run boxier, with a shorter overhang and a squarer corner where the roof meets the rear glass. It's a real difference, but it's a few pixels' worth at typical resolution, and it degrades fast on anything shot off a lower-resolution pass.

Color is the cue that does the heavy lifting in most frames, assuming it survived compression and isn't a repaint or a rental livery with its own scheme slapped over factory paint. Deere runs yellow hood over green frame. Case runs red. When color comes through clean, it resolves the call faster than hood line or cab shape ever will on their own. The counterweight block at the rear is the third input worth checking, since the step-down profile of the ballast casting differs enough between the two that it's worth a glance once the other two cues disagree.

Stack all three (shadow length, cab outline, color) and you get a confident call most of the time. Pull any one of them out, especially color, and you're guessing with extra steps.

Where this breaks down on a real site count

A count of "six wheel loaders" tells you nothing about who's winning share on that job. Turning that six into "four Deere, two Case" is the actual competitive read, and it's a harder one than counting, because every cue above has a failure mode baked in. That's the gap Machine Brand Recognition is built to close: reading color, hood geometry and counterweight silhouette together across a site's detected fleet, rather than asking one analyst to eyeball each frame and hope the sun angle cooperated.

If attributing a fleet count to manufacturers is the part of your job that eats the most review time, that's the use case worth getting on the pilot list for.

Join the pilot list